tandberg 2500 on IP network

[probert100]

Hello,
We have a TANDBERG 2500 CODEC that is currently connected to 6 ISDN lines. We want to use it on our IP network. Looking at the documantation from tandberg's website we are convinced that it should be possible, but it looks like our device is missing some of the menu options for example: "LAN Settings" menu under the "Terminal Settings" is missing.

Here is the software version:
Software Version C3.1 NTSC

Do we need to upgrade the software?
If so can someone point us in the right direction?

Thanks

[Darren Goulden]

Hi probert100,

Unfortunatelly you cannot use your 2500 Vision codec for H323 video. The TANDBERG Vision 2500 codec supports TCP/IP connectivity over Ethernet.
The following functionalities are supported:

Control of the system via a standard WWW-browser
Dataport access using Telnet
Software Upgrade using WWW-browser or FTP
SNMP (Simple Network Management Protocol) (MIB-II)

[trapehzoid]

that was from tandberg reusing product names. you have the generation before they enabled H.323. there are later products also called '2500' that do support H.323

[probert100]

Thank you very much for all of the responses.
I was afraid it will not be as simple as updating the software.

Robert