n_akinyemi
11-08-2006, 05:43 AM
hello all
I have a 2 multiVOIP over a PTP IP network connected using E&M interfaces on both the gateway and the PBX.
Issue here is that the local can receive but not call the remote. Users at the local dial an access code then the after getting a dialtone dial any extension at the remote: all i get is an shh sound.
The multitech are configured ton pass thru any number nad when I do a GUI to the remote I see the prefix matched for the extension i dialled and bytes received counters increase while bytes sent remain zero.
This config worked for some time then....please help i am a trainee engineer from nigeria.
I have a 2 multiVOIP over a PTP IP network connected using E&M interfaces on both the gateway and the PBX.
Issue here is that the local can receive but not call the remote. Users at the local dial an access code then the after getting a dialtone dial any extension at the remote: all i get is an shh sound.
The multitech are configured ton pass thru any number nad when I do a GUI to the remote I see the prefix matched for the extension i dialled and bytes received counters increase while bytes sent remain zero.
This config worked for some time then....please help i am a trainee engineer from nigeria.