JFCOMEngineer
05-27-2008, 12:50 PM
I am in the process of setting up a Tandberg MPS 800 on my classified enterprise network. We are primarily a Tandberg shop, and have a Tandberg gatekeeper and border controller, and 75 or so endpoints. I have a v.35 serial card in the MPS connected to an Atlas 890 via KIV-7HSBs and Dial isolators. The Atlas has two Quad PRI interfaces, one provisioned with a 1D95B NFAS group from DISA, and the other provisioned with a single commercial PRI. I have two bonding modules, and 4 dual video modules.
Can anyone point me towards how to set up the Atlas to be able to specify which video port is used? I have a mental image of using a dialing suffix, so that by appending a string such as #21 to the single dial in for the NFAS it would route the call through port one of the DV card in slot 10, #22 through port two of the DV card in slot 10, #23 through port one of the DV card in slot 11, #24 through port two of the DV card in slot 11, etc.
The #$%$% Adtran gear is so reliable that in the years between having to touch it I have forgotten what little I knew, and am having to relearn everything.
Can anyone point me towards how to set up the Atlas to be able to specify which video port is used? I have a mental image of using a dialing suffix, so that by appending a string such as #21 to the single dial in for the NFAS it would route the call through port one of the DV card in slot 10, #22 through port two of the DV card in slot 10, #23 through port one of the DV card in slot 11, #24 through port two of the DV card in slot 11, etc.
The #$%$% Adtran gear is so reliable that in the years between having to touch it I have forgotten what little I knew, and am having to relearn everything.